Hardware Projects

Proof-of-Concept and development of a demonstrator for smart wireless therapeutic devices

2019 - UniTransferKlinik Lübeck GmbH & Sachtleben GmbH.

During this project I developed the diagram block of the system. Aferwards, the selection of the componets took place. In order to proof the bluetooth protocol communication, a small PCB was created which controlled a servo motor and an inductance. Power consumption tests were done with the help of the Cassy Lab 2 hardware and software. The PSoC® 63 from Cypress was used as the microcontroller of the project.

Concept of a Bluetooth Master Device in a Sensor Network up to Fourteen Slaves

2017 - GAIA GmbH.

I developed this proyect for my Master's thesis. The device consited in two mayor componets namely,Raspberry Pi Zero W and a Nordic Bluetooth Module (nRF52832). The protocol I2C was implemented to connect both modelues.A PCb was assambled with Eagle software for the nordic chip and the I2C connections.

Pulsoxymeter device

2016 - Universität zu Lübeck & Fachhochschule Lübeck, Germany

This project was carried out with the help an international group. The fisrt part was to sketch the module diagram. With this blocks, we could sketchthe our circuit with all the componets and their values. Afterwards, this circuit was tested in a simulation to know if the componets values were the correct. At the end, a PCB for the project was digitalized by Eagle software and sent it to be manufactured then componets could be soldered and tested on an oscilocope.

Concept of a device for pumping reagents in disposable analysis systems

2056 - Universität zu Lübeck & Fachhochschule Lübeck, Germany

The project was completed in conjunction with an international membership group in which model V was implemented to develop the concept for a disposable agent pumping device. The design phase was customer requirements, technical requirements, device design, verification and validation of the project.